Coaxial cables: RG-59/U
STEP 1:
Slide nut, washer and gasket over jacket, and cut off jacket 19/32″ from end of cable as shown.
STEP 2:
Comb out braid, pull braid wires forward and taper toward conductor.
STEP 3:
Place clamp over braid and push back against cable jacket. Fold back braid wires as shown, trim to proper length and evenly form over clamp as shown. Cut dielectric to 1/8″ dimension as shown. Tin exposed conductor using minimum amount of heat.
STEP 4:
Solder contact to conductor. Remove excess flux and solder from outside of contact.
STEP 5:
Insert prepared cable termination into plug body. Tighten nut moderately, holding plug body stationary.