Coaxial cables: RG-8/U, RG-9/U, RG-213/U, RG-214/U, RG-225/U
STEP 1:
Place nut and gasket with “V” groove toward clamp over cable and cut jacket to the dimension shown.
STEP 2:
Comb out braid and fold out. Cut off cable dielectric to the dimensions shown.
STEP 3:
Pull braid wires forward and taper toward conductor. Place clamp over braid so that the inner shoulder fits against the end of the cable jacket.
STEP 4:
Fold back braid as shown, trim to proper length and form over clamp as shown. Solder contact to center conductor.
STEP 5:
Insert cable and parts into connector body. Make sure sharp edge of clamp seats properly in gasket. Tighten nut.